分页: 1 / 1

令人郁闷的RT3090

发表于 : 2011-02-22 10:30
xinghu
联想B450的本子,新安装的ubuntu10.10。安装了rt3090sta的驱动,无线始终不能用,求指点!感激不尽!

lspci

代码: 全选

00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller Hub (rev 07)
00:01.0 PCI bridge: Intel Corporation Mobile 4 Series Chipset PCI Express Graphics Port (rev 07)
00:1a.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #4 (rev 03)
00:1a.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #5 (rev 03)
00:1a.2 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #6 (rev 03)
00:1a.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #2 (rev 03)
00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio Controller (rev 03)
00:1c.0 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 1 (rev 03)
00:1c.1 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 2 (rev 03)
00:1d.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #1 (rev 03)
00:1d.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #2 (rev 03)
00:1d.2 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #3 (rev 03)
00:1d.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #1 (rev 03)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev 93)
00:1f.0 ISA bridge: Intel Corporation ICH9M LPC Interface Controller (rev 03)
00:1f.2 IDE interface: Intel Corporation ICH9M/M-E 2 port SATA IDE Controller (rev 03)
00:1f.3 SMBus: Intel Corporation 82801I (ICH9 Family) SMBus Controller (rev 03)
00:1f.5 IDE interface: Intel Corporation ICH9M/M-E 2 port SATA IDE Controller (rev 03)
01:00.0 VGA compatible controller: nVidia Corporation G98M [GeForce G105M] (rev a2)
01:00.1 Audio device: nVidia Corporation High Definition Audio Controller (rev a1)
02:00.0 Ethernet controller: Atheros Communications AR8132 Fast Ethernet (rev c0)
03:00.0 Network controller: RaLink RT3090 Wireless 802.11n 1T/1R PCIe

lsmod | grep sta

代码: 全选

rt3090sta             882862  1
执行ifconfig ra0 up 后,

iwconfig;

代码: 全选

lo        no wireless extensions.

eth0      no wireless extensions.

ra0       Ralink STA  ESSID:""  Nickname:"RT2860STA"
          Mode:Auto  Frequency=2.412 GHz  Access Point: Not-Associated   
          Bit Rate:1 Mb/s   
          RTS thr:off   Fragment thr:off
          Link Quality=10/100  Signal level:0 dBm  Noise level:-95 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

ifconfig:

代码: 全选

eth0      Link encap:以太网  硬件地址 00:26:2d:fc:95:cb  
          inet 地址:192.168.8.208  广播:192.168.8.255  掩码:255.255.255.0
          inet6 地址: fe80::226:2dff:fefc:95cb/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  跃点数:1
          接收数据包:20897 错误:0 丢弃:0 过载:0 帧数:0
          发送数据包:8566 错误:0 丢弃:0 过载:0 载波:1
          碰撞:0 发送队列长度:1000 
          接收字节:10867296 (10.8 MB)  发送字节:1013704 (1.0 MB)
          中断:44 

lo        Link encap:本地环回  
          inet 地址:127.0.0.1  掩码:255.0.0.0
          inet6 地址: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  跃点数:1
          接收数据包:304 错误:0 丢弃:0 过载:0 帧数:0
          发送数据包:304 错误:0 丢弃:0 过载:0 载波:0
          碰撞:0 发送队列长度:0 
          接收字节:10307 (10.3 KB)  发送字节:10307 (10.3 KB)

ra0       Link encap:以太网  硬件地址 00:26:82:3a:4f:97  
          inet6 地址: fe80::226:82ff:fe3a:4f97/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  跃点数:1
          接收数据包:6179 错误:0 丢弃:0 过载:0 帧数:0
          发送数据包:3157 错误:0 丢弃:0 过载:0 载波:0
          碰撞:0 发送队列长度:1000 
          接收字节:970937 (970.9 KB)  发送字节:0 (0.0 B)
          中断:17 


但是,依然显示无线网卡已禁用!
求高人!!!

Re: 令人郁闷的RT3090

发表于 : 2011-03-02 13:07
zxj85
你看看这个帖子,我用ppa装的正常,也是B450

viewtopic.php?f=48&t=290991&start=0

不过现在几次升级内核都不像原来那样会自动挂载驱动模块,郁闷

Re: 令人郁闷的RT3090

发表于 : 2011-03-02 13:44
xinghu
zxj85 写了:你看看这个帖子,我用ppa装的正常,也是B450

viewtopic.php?f=48&t=290991&start=0

不过现在几次升级内核都不像原来那样会自动挂载驱动模块,郁闷
谢谢! 今天我刚升级的内核,ppa不能安装了。重新编译安装的驱动,好了已经。