当前时区为 UTC + 8 小时



发表新帖 回复这个主题  [ 2 篇帖子 ] 
作者 内容
1 楼 
 文章标题 : 求助高手驱动问题
帖子发表于 : 2009-08-09 19:19 

注册: 2009-07-12 17:18
帖子: 22
送出感谢: 0 次
接收感谢: 0 次
:em20
小弟今天想安装声卡驱动,但不知怎么安装,驱动文档如下
Audio driver for CM8338/CM8738 chips by Chen-Li Tien





HARDWARE SUPPORTED

================================================================================

C-Media CMI8338

C-Media CMI8738

On-board C-Media chips





STEPS TO BUILD DRIVER

================================================================================



1. Backup the Config.in and Makefile in the sound driver directory

(/usr/src/linux/driver/sound).

The Configure.help provide help when you config driver in step

4, please backup the original one (/usr/src/linux/Document) and

copy this file.

The cmpci is document for the driver in detail, please copy it

to /usr/src/linux/Document/sound so you can refer it. Backup if

there is already one.



2. Extract the tar file by 'tar xvzf cmpci-xx.tar.gz' in the above

directory.



3. Change directory to /usr/src/linux



4. Config cm8338 driver by 'make menuconfig', 'make config' or

'make xconfig' command.



5. Please select Sound Card (CONFIG_SOUND=m) support and CMPCI

driver (CONFIG_SOUND_CMPCI=m) as modules. Resident mode not tested.

For driver option, please refer 'DRIVER PARAMETER'



6. Compile the kernel if necessary.



7. Compile the modules by 'make modules'.



8. Install the modules by 'make modules_install'





INSTALL DRIVER

================================================================================



1. Before first time to run the driver, create module dependency by

'depmod -a'



2. To install the driver manually, enter 'modprobe cmpci'.



3. Driver installation for various distributions:



a. Slackware 4.0

Add the 'modprobe cmpci' command in your /etc/rc.d/rc.modules

file.so you can start the driver automatically each time booting.



b. Caldera OpenLinux 2.2

Use LISA to load the cmpci module.



c. RedHat 6.0 and S.u.S.E. 6.1

Add following command in /etc/conf.modules:



alias sound cmpci



also visit http://www.cmedia.com.tw for installation instruction.



DRIVER PARAMETER

================================================================================



Some functions for the cm8738 can be configured in Kernel Configuration

or modules parameters. Set these parameters to 1 to enable.



mpu_io: I/O ports base for MPU-401, 0 if disabled.

fm_io: I/O ports base for OPL-3, 0 if disabled.

spdif_inverse:Inverse the S/PDIF-in signal, this depends on your

CD-ROM or DVD-ROM.

spdif_loop: Enable S/PDIF loop, this route S/PDIF-in to S/PDIF-out

directly.

speakers: Number of speakers used.

use_line_as_rear:Enable this if you want to use line-in as

rear-out.

use_line_as_bass:Enable this if you want to use line-in as

bass-out.

modem: You will need to set this parameter if you want to use

the HSP modem. You need install the pctel.o, the modem

driver itself.

joystick: Enable joystick. You will need to install Linux joystick

driver.

请各位录高的高手指导一下,谢谢!


页首
 用户资料  
 
2 楼 
 文章标题 : Re: 求助高手驱动问题
帖子发表于 : 2009-08-09 19:22 
头像

注册: 2006-07-02 11:16
帖子: 12522
地址: 廣州
送出感谢: 0 次
接收感谢: 8
系统有声音吗?


_________________
^_^ ~~~
要理解递归,首先要理解递归。

地球人都知道,理论上,理论跟实际是没有差别的,但实际上,理论跟实际的差别是相当大滴。


页首
 用户资料  
 
显示帖子 :  排序  
发表新帖 回复这个主题  [ 2 篇帖子 ] 

当前时区为 UTC + 8 小时


在线用户

正在浏览此版面的用户:没有注册用户 和 4 位游客


不能 在这个版面发表主题
不能 在这个版面回复主题
不能 在这个版面编辑帖子
不能 在这个版面删除帖子
不能 在这个版面提交附件

前往 :  
本站点为公益性站点,用于推广开源自由软件,由 DiaHosting VPSBudgetVM VPS 提供服务。
我们认为:软件应可免费取得,软件工具在各种语言环境下皆可使用,且不会有任何功能上的差异;
人们应有定制和修改软件的自由,且方式不受限制,只要他们自认为合适。

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
简体中文语系由 王笑宇 翻译