poppler-data 与 CheckInstall问题

重复贴和参考价值不大的帖子,版主维护
回复
chenhonjin
帖子: 16
注册时间: 2007-11-08 8:51
送出感谢: 0
接收感谢: 0

poppler-data 与 CheckInstall问题

#1

帖子 chenhonjin » 2007-12-16 5:45

我在主页上下载了poppler-data-0.2.0,解压安装时,没有configure文件,看了一下readme文件,但又看得不太懂,找google翻译,看得我更加乱翻译,狂晕,干脆咬咬牙,发上来研究研究,大家不要见笑,刚接触linux,问题比较菜

**************************************************************
-*- text -*-
poppler-data

This package consists of encoding files for use with poppler. The
encoding files are optional and poppler will automatically read them
if they are present. When installed, the encoding files enables
poppler to correctly render CJK and Cyrrilic properly. While poppler
is licensed under the GPL, these encoding files are copyright Adobe
and licensed much more strictly, and thus distributed separately.

All the Makefile does is install the data files, so autotools seemed a
bit overkill. There is no ./configure file, all there is to do is to
say 'make install'. To override the install destinations, specify
prefix, datadir, pkgdatadir or DESTDIR at 'make install' time as
desired. For example:

$ make install datadir=/usr DESTDIR=/tmp/buildroot-xyz2000(注,特别是这句,俺最不解!)

will install the files under /usr/share/poppler in a temporary build
root.

Kristian Høgsberg <krh@redhat.com>
**************************************************************

对了,我用的是ubuntu7.10
请各位帮帮忙,解释一下是怎么安装
还有,听说编译之后很难卸载,我用上了CheckInstall,可是
使用:
auto-apt run ./configure 代替 ./configure
make 不变 make
sudo check install 代替 make install

没有configure怎么办,有谁能告知用checkinstall方法来安装没有configure文件的poppler-data-0.2.0步骤!!
就此谢过!!!!!
上次由 chenhonjin 在 2007-12-16 15:55,总共编辑 1 次。
头像
windwiny
帖子: 2254
注册时间: 2007-03-13 17:26
送出感谢: 0
接收感谢: 1 次

#2

帖子 windwiny » 2007-12-16 14:25

make install datadir=/usr/share
chenhonjin
帖子: 16
注册时间: 2007-11-08 8:51
送出感谢: 0
接收感谢: 0

#3

帖子 chenhonjin » 2007-12-16 15:21

什么意思,能否尽可能讲详尽量讲详细点,不解!
回复

回到 “归档贴”