[问题]kubuntu已经能识别手柄，PCSX2却不能用

Finalazy · #1

手柄是北通的震动3
有没有人试过？

eexpress · #2

没用过。估计是软件里面的设置。一般的模拟器，都有f2或者tab开设置界面的。

Finalazy · #3

它是没得选用键盘还是手柄啊～
可能要有支持手柄的Plugins

Finalazy · #4

在pcsx2论坛找到这个

There is no joystik support in linux. I was working on it, but its kind of sitting half finshed in my basement cause i havent had any time since i started. I worked for about 30 minutes and then all of a sudden i havent even been able to turn my computer on since.

There is a happy medium i believe. if you have qt3 installed, you should be able to use qjoypad. what qjoypad does is it acts like a sort of virtual keyboard if you will. Basically it allows you to map controller buttons to existing keyboard mappings in X. In the end you should be able to get everything working, except for maybe the joysticks themselves.

This was my understanding from reading it. i havent actually done it though. if you do get it working, give the devs a shout so that they can sticky it temporarily or something

QJoyPad

there is the website for you if you want to check it out.

看来键盘映射是现在唯一的办法了...