[问题] 安装cadence ic5033中遇到的 问题？

[coconuttree01]

运行SETUP.SH后

Located CDROM at /mnt/cdrom-1

Specify path of install directory [OR type [RETURN] to exit]: /home/ic5033

Setting up softload for lnx86 in /home/ic5033

The following tar errors were detected:
/bin/tar: 从成员名中删除开头的“/”

Could not set up SoftLoad in /home/ic5033

You must have write permissions to install directory and all its subdirectories
and atleast 10 MB available disk space in install directory.

Specify path of install directory [OR type [RETURN] to exit]:

请大家帮忙看看（ 我用root安装的，硬盘空间足够大）。

[keenboyee]

我在7。04下安装cadence spb155时也出现了相同的错误，不知道该怎么解决

[radar]

something wrong with your tar, you should check this forum

www.edaboard.com

I'm going to install it too, hopefully I can get it done:)

[sakulaqi]

if ubuntu's version >=606
it is impossible to run ic5<5141usr4 (5141 is ok) or spb.
i don't konw about spb/157 because i cannot got it from anywhere.

[marcusliang]

I try to install Cadence IC5141 on ubuntu 7.04; however it is not work after I type icfb&.
the system shows errors.
I am afraid my installation is not correct.

[timchu]

出现这个错误后，进入 /home/ic5033
然后里边有个install/linux.lnx（忘记了）
里边有个softload吧。运行那个就可以安装了







quote="coconuttree01"]运行SETUP.SH后

Located CDROM at /mnt/cdrom-1

Specify path of install directory [OR type [RETURN] to exit]: /home/ic5033

Setting up softload for lnx86 in /home/ic5033

The following tar errors were detected:
/bin/tar: 从成员名中删除开头的“/”

Could not set up SoftLoad in /home/ic5033

You must have write permissions to install directory and all its subdirectories
and atleast 10 MB available disk space in install directory.

Specify path of install directory [OR type [RETURN] to exit]:

请大家帮忙看看（ 我用root安装的，硬盘空间足够大）。[/quote]

[coolgezi]

我是在REDHAT 4.7下面安装IC5141的，并能成功运行，画版图。如果要在ubuntu下面安装的话，会提示tar的版本有问题，或者缺少些什么库之类的。