ubuntu 8.04安装madwifi注入驱动的问题,airmon-ng start wifi0 没用,求助!
发表于 : 2008-10-30 10:48
ubuntu 8.04系统内核更新到2.6.24-21,Cisco CB21AG-A-K9网卡,安装过程如下:
ifconfig ath0 down
ifconfig wifi0 down
svn -r 3745 checkout http://svn.madwifi.org/madwifi/trunk/ madwifi-ng
wget http://patches.aircrack-ng.org/madwifi-ng-r3745.patch
cd madwifi-ng
patch -Np1 -i ../madwifi-ng-r3745.patch
./scripts/madwifi-unload
make
make install
depmod -ae
modprobe ath_pci
按照aircrack-ng网站的教程安装的,输入airmon-ng start wifi0显示
airmon-ng start wifi0
Interface Chipset Driver
eth1 Intel 2200BG ipw2200
ath0 Atheros madwifi-ng VAP (parent: wifi0)
没有出现ath1 就是那个监听monitor的端口,只能手动输入下面命令才能打开监听端口
ifconfig ath0 down
wlanconfig ath0 destroy
wlanconfig ath0 create wlandev wifi0 wlanmode monitor
ifconfig ath0 up
现在ath0处于监听状态,但是就不能上网了要上网的话只能再手动切换回来,不过所有aircrack-ng 套件都能正常使用;我试了在backtrack 3 beta 里面写在驱动再安装在输入airmon-ng start wifi0命令也出现错误,但能打开监听端口,请问诸位是怎么安装注入驱动的,还请告知,谢谢!
ifconfig ath0 down
ifconfig wifi0 down
svn -r 3745 checkout http://svn.madwifi.org/madwifi/trunk/ madwifi-ng
wget http://patches.aircrack-ng.org/madwifi-ng-r3745.patch
cd madwifi-ng
patch -Np1 -i ../madwifi-ng-r3745.patch
./scripts/madwifi-unload
make
make install
depmod -ae
modprobe ath_pci
按照aircrack-ng网站的教程安装的,输入airmon-ng start wifi0显示
airmon-ng start wifi0
Interface Chipset Driver
eth1 Intel 2200BG ipw2200
ath0 Atheros madwifi-ng VAP (parent: wifi0)
没有出现ath1 就是那个监听monitor的端口,只能手动输入下面命令才能打开监听端口
ifconfig ath0 down
wlanconfig ath0 destroy
wlanconfig ath0 create wlandev wifi0 wlanmode monitor
ifconfig ath0 up
现在ath0处于监听状态,但是就不能上网了要上网的话只能再手动切换回来,不过所有aircrack-ng 套件都能正常使用;我试了在backtrack 3 beta 里面写在驱动再安装在输入airmon-ng start wifi0命令也出现错误,但能打开监听端口,请问诸位是怎么安装注入驱动的,还请告知,谢谢!