量产U盘如何挂载
发表于 : 2009-10-30 14:35
8G的U盘 量产成三区
一个CDROM 一个固定盘一个移动盘
插上U盘
只能得到这些信息
jk@jk-laptop:~$ sudo fdisk -l
Disk /dev/sda: 120.0 GB, 120034123776 bytes
255 heads, 63 sectors/track, 14593 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0xc3ffc3ff
Device Boot Start End Blocks Id System
/dev/sda1 * 1 3917 31463271 7 HPFS/NTFS
/dev/sda2 3918 14593 85754970 f W95 Ext'd (LBA)
/dev/sda5 3918 7181 26218048+ 7 HPFS/NTFS
/dev/sda6 7182 11750 36700461 7 HPFS/NTFS
/dev/sda7 11751 12966 9767488+ 83 Linux
/dev/sda8 12967 13215 2000061 82 Linux swap / Solaris
/dev/sda9 13216 13337 979933+ 83 Linux
/dev/sda10 13338 14593 10088788+ 83 Linux
jk@jk-laptop:~$
dmesg | tail
[ 2497.628204] usb 3-1: device descriptor read/64, error -110
[ 2512.844112] usb 3-1: device descriptor read/64, error -110
[ 2513.060123] usb 3-1: new full speed USB device using uhci_hcd and address 3
[ 2528.172326] usb 3-1: device descriptor read/64, error -110
[ 2543.388140] usb 3-1: device descriptor read/64, error -110
[ 2543.604140] usb 3-1: new full speed USB device using uhci_hcd and address 4
[ 2554.012118] usb 3-1: device not accepting address 4, error -110
[ 2554.124131] usb 3-1: new full speed USB device using uhci_hcd and address 5
[ 2564.532324] usb 3-1: device not accepting address 5, error -110
[ 2564.532361] hub 3-0:1.0: unable to enumerate USB device on port 1
应该怎么整?
一个CDROM 一个固定盘一个移动盘
插上U盘
只能得到这些信息
jk@jk-laptop:~$ sudo fdisk -l
Disk /dev/sda: 120.0 GB, 120034123776 bytes
255 heads, 63 sectors/track, 14593 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0xc3ffc3ff
Device Boot Start End Blocks Id System
/dev/sda1 * 1 3917 31463271 7 HPFS/NTFS
/dev/sda2 3918 14593 85754970 f W95 Ext'd (LBA)
/dev/sda5 3918 7181 26218048+ 7 HPFS/NTFS
/dev/sda6 7182 11750 36700461 7 HPFS/NTFS
/dev/sda7 11751 12966 9767488+ 83 Linux
/dev/sda8 12967 13215 2000061 82 Linux swap / Solaris
/dev/sda9 13216 13337 979933+ 83 Linux
/dev/sda10 13338 14593 10088788+ 83 Linux
jk@jk-laptop:~$
dmesg | tail
[ 2497.628204] usb 3-1: device descriptor read/64, error -110
[ 2512.844112] usb 3-1: device descriptor read/64, error -110
[ 2513.060123] usb 3-1: new full speed USB device using uhci_hcd and address 3
[ 2528.172326] usb 3-1: device descriptor read/64, error -110
[ 2543.388140] usb 3-1: device descriptor read/64, error -110
[ 2543.604140] usb 3-1: new full speed USB device using uhci_hcd and address 4
[ 2554.012118] usb 3-1: device not accepting address 4, error -110
[ 2554.124131] usb 3-1: new full speed USB device using uhci_hcd and address 5
[ 2564.532324] usb 3-1: device not accepting address 5, error -110
[ 2564.532361] hub 3-0:1.0: unable to enumerate USB device on port 1
应该怎么整?