大大帮忙看看xorg.conf

[artless]

# xorg.conf (X.Org X Window System server configuration file)
#
# This file was generated by dexconf, the Debian X Configuration tool, using
# values from the debconf database.
#
# Edit this file with caution, and see the xorg.conf manual page.
# (Type "man xorg.conf" at the shell prompt.)
#
# This file is automatically updated on xserver-xorg package upgrades *only*
# if it has not been modified since the last upgrade of the xserver-xorg
# package.
#
# Note that some configuration settings that could be done previously
# in this file, now are automatically configured by the server and settings
# here are ignored.
#
# If you have edited this file but would like it to be automatically updated
# again, run the following command:
# sudo dpkg-reconfigure -phigh xserver-xorg

Section "Device"
Identifier "Configured Video Device"
EndSection

Section "Monitor"
Identifier "Configured Monitor"
EndSection

Section "Screen"
Identifier "Default Screen"
Monitor "Configured Monitor"
Device "Configured Video Device"
EndSection

问题：
1，xorg.conf怎么没有显示设备。
2，窗口最大化有时只有2／3屏幕高度，更改刷新频率能恢复正常。
3，重装compiz后，无法开启动外观－视觉效果－正常。

安装时正常，第一次启动白屏，无法进入X，remove compiz 后能进入X。

[Terpineol]

显卡驱动还没有装吧？

[artless]

显卡驱动还没有装吧？

谢谢！
驱动不知为什么不能安装，总是出错。但现在能更改刷新、分辨率，应该有驱动。

[lerosua]

谢谢！
驱动不知为什么不能安装，总是出错。但现在能更改刷新、分辨率，应该有驱动。

也可能用的是通用驱动而已

[Terpineol]

什么显卡？默认的vesa驱动当然不支持3d功能了

[artless]

什么显卡？默认的vesa驱动当然不支持3d功能了

古董，845。

[artless]

安装IntelGraphics_060704.tar.gz一堆错误。

[artless]

窗口最大化有时只有2／3屏幕高度，更改刷新频率能恢复正常。为什么？

[Terpineol]

845应该不用装驱动的，不能用就不好说了，主板原因？显示器不正常可能是没有认出显器

[artless]

显示器认错了，15‘’成14‘’。

[artless]

viewtopic.php?f=42&t=1689&start=27