网络配置文件里面的eth0和eth1为什么和实际的是相反的？

[fayejt]

配置文件如下

代码： 全选

auto lo
iface lo inet loopback

auto eth0
iface eth0 inet dhcp

#iface eth1 inet dhcp

#auto eth2
#iface eth2 inet dhcp

#auto ath0
#iface ath0 inet dhcp

#auto wlan0
#iface wlan0 inet dhcp

而ifconfig的结果是

代码： 全选

eth0      Link encap:Ethernet  HWaddr （MAC地址省略）  
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:20 Base address:0x6000 

eth1      Link encap:Ethernet  HWaddr （MAC地址省略） 
          inet addr:58.30.XX.XX（省略）  Bcast:255.255.255.255  Mask:255.255.240.0
          inet6 addr: fe80::205:5dff:fe0f:a66d/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:941 errors:0 dropped:0 overruns:0 frame:0
          TX packets:509 errors:0 dropped:0 overruns:0 carrier:0
          collisions:1 txqueuelen:1000 
          RX bytes:978655 (955.7 KiB)  TX bytes:56224 (54.9 KiB)
          Interrupt:19 Base address:0xa000 

eth0:avah Link encap:Ethernet  HWaddr 00:11:09:C0:C5:C4  
          inet addr:169.254.9.76  Bcast:169.254.255.255  Mask:255.255.0.0
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          Interrupt:20 Base address:0x6000 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:2 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:100 (100.0 b)  TX bytes:100 (100.0 b)

结果是eth1得到了IP，我都迷糊了~~~~


还有，那个eth0:avah是什么意思啊
谢谢

[fayejt]

没人知道么？

[arkar]

在/etc/iftab里指定名称也许可以解决

[EI]

同问