这是我的 /etc/network/interfaces 文件内容
代码： 全选
auto lo
iface lo inet loopback
iface eth0 inet static
address 192.168.2.11
netmask 255.255.255.0
gateway 192.168.2.1
iface wifi0 inet static
address 192.168.2.11
netmask 255.255.255.0
gateway 192.168.2.1
wireless-key restricted 362880BBBB
wireless-essid TP-LINK
auto wifi0
iface dsl-provider inet ppp
pre-up /sbin/ifconfig eth0 up # line maintained by pppoeconf
provider dsl-provider
auto eth0这是我用iwconfig命令看到的结果
代码： 全选
linphy@linphy-laptop:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wifi0 IEEE 802.11b ESSID:"TP-LINK" Nickname:""
Mode:Managed Frequency:2.437 GHz Access Point: 00:1D:0F:59:A4:A0
Bit Rate:11 Mb/s Sensitivity=1/3
Retry short limit:8 RTS thr:off Fragment thr:off
Power Management:off
wlan0 IEEE 802.11b ESSID:"TP-LINK" Nickname:""
Frequency:2.437 GHz Access Point: 00:1D:0F:59:A4:A0
Bit Rate:11 Mb/s Sensitivity=1/3
Retry short limit:8 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=62/70 Signal level=-33 dBm Noise level=-96 dBm
Rx invalid nwid:0 Rx invalid crypt:184 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:2094 Missed beacon:0
irda0 no wireless extensions.这是我查看IP分配情况看到的结果
代码： 全选
linphy@linphy-laptop:~$ sudo lshw -C network
*-network:0 DISABLED
description: Wireless interface
product: Prism 2.5 Wavelan chipset
vendor: Intersil Corporation
physical id: 2
bus info: pci@0000:02:02.0
logical name: wifi0
version: 01
serial: 00:05:3c:08:46:4b
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list logical wireless ethernet physical
configuration: broadcast=yes driver=hostap firmware=1.4.9 ip=192.168.2.11 latency=64 module=hostap_pci multicast=yes wireless=IEEE 802.11b
*-network:1
description: Ethernet interface
product: 82801CAM (ICH3) PRO/100 VE (LOM) Ethernet Controller
vendor: Intel Corporation
physical id: 8
bus info: pci@0000:02:08.0
logical name: eth0
version: 41
serial: 00:d0:59:be:d4:5b
size: 100MB/s
capacity: 100MB/s
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=e100 driverversion=3.5.23-k4-NAPI duplex=full firmware=N/A ip=192.168.2.12 latency=66 link=yes maxlatency=56 mingnt=8 module=e100 multicast=yes port=MII speed=100MB/s这是我用ifconfig命令看到的结果
代码： 全选
linphy@linphy-laptop:~$ ifconfig
eth0 Link encap:以太网 硬件地址 00:d0:59:be:d4:5b
inet 地址:192.168.2.12 广播:192.168.2.255 掩码:255.255.255.0
inet6 地址: fe80::2d0:59ff:febe:d45b/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 跃点数:1
接收数据包:611 错误:0 丢弃:0 过载:0 帧数:0
发送数据包:66 错误:0 丢弃:0 过载:0 载波:0
碰撞:0 发送队列长度:1000
接收字节:37224 (36.3 KB) 发送字节:8921 (8.7 KB)
lo Link encap:本地环回
inet 地址:127.0.0.1 掩码:255.0.0.0
inet6 地址: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 跃点数:1
接收数据包:3068 错误:0 丢弃:0 过载:0 帧数:0
发送数据包:3068 错误:0 丢弃:0 过载:0 载波:0
碰撞:0 发送队列长度:0
接收字节:155809 (152.1 KB) 发送字节:155809 (152.1 KB)
wifi0 Link encap:未指定 硬件地址 00-05-3C-08-46-4B-00-00-00-00-00-00-00-00-00-00
inet 地址:192.168.2.11 广播:192.168.2.255 掩码:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 跃点数:1
接收数据包:452 错误:0 丢弃:0 过载:0 帧数:0
发送数据包:7 错误:0 丢弃:119 过载:0 载波:0
碰撞:0 发送队列长度:1000
接收字节:38428 (37.5 KB) 发送字节:684 (684.0 B)
中断:11
