简单安装ati8.42.3驱动。
发表于 : 2007-10-26 15:51
假如之前你是用xgl的,请执行以下命令移除旧的fglrx驱动
sudo apt-get remove xserver-xgl
然后到“系统”-“系统管理”-“受限驱动管理器” 处取消掉之前的驱动,或者也可以执行:
sudo apt-get remove xorg-driver-fglrx
下载驱动:
http://www2.ati.com/drivers/linux/ati-d ... x86_64.run
然后打开终端:
sudo cp /etc/X11/xorg.conf /etc/X11/xorg.conf.bak (备份下,方便恢复)
sudo gedit /etc/X11/xorg.conf
如果存在下面字段,就移除
Section “Extensions”
Option “Composite” “0″ # or “Disable”
EndSection
Section “ServerFlags”
Option “AIGLX” “off”
EndSection
然后直接cd到你存放驱动文件的文件夹,,运行:
sudo bash "ati-driver-installer-8.42.3-x86.x86_64.run"
按照安装程序一步步按 next就装好了
然后重启下电脑,进入系统-首选项-外观-视觉效果
把compiz打开就OK
如果原来没安装过fglrx驱动的可能要再执行
sudo aticonfig --initial -f
我安装完3D、2D都没问题。
如果原来装过的直接再覆盖安装就行了
sudo apt-get remove xserver-xgl
然后到“系统”-“系统管理”-“受限驱动管理器” 处取消掉之前的驱动,或者也可以执行:
sudo apt-get remove xorg-driver-fglrx
下载驱动:
http://www2.ati.com/drivers/linux/ati-d ... x86_64.run
然后打开终端:
sudo cp /etc/X11/xorg.conf /etc/X11/xorg.conf.bak (备份下,方便恢复)
sudo gedit /etc/X11/xorg.conf
如果存在下面字段,就移除
Section “Extensions”
Option “Composite” “0″ # or “Disable”
EndSection
Section “ServerFlags”
Option “AIGLX” “off”
EndSection
然后直接cd到你存放驱动文件的文件夹,,运行:
sudo bash "ati-driver-installer-8.42.3-x86.x86_64.run"
按照安装程序一步步按 next就装好了
然后重启下电脑,进入系统-首选项-外观-视觉效果
把compiz打开就OK
如果原来没安装过fglrx驱动的可能要再执行
sudo aticonfig --initial -f
我安装完3D、2D都没问题。
如果原来装过的直接再覆盖安装就行了